Installing The Unit - Kenwood DDX6015BT Instruction Manual

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Supplied accessories for installation
1 Wiring harness x 1
2 Trim plate* 1 x 1
3 Extension wire (2 m) x 1
4 Flat head screws (M5 x 8 mm) x 6*
5 Round head screws (M5 x 8 mm) x 6
6 Steering Remote cable x 1
7 Microphone (3 m)* x 1
3
* Only for DDX4015BT.
1
*
2 Only for DDX6015BT/DDX4015BT/DDX415BT/DDX415BTM/DDX315/
DDX315M.
* Only for DDX6015BT/DDX4015BT/DDX415BT/DDX415BTM/
3
DDX615WBT/DDX615WBTM.
Installation procedure
1
To prevent a short circuit, remove the key
from the ignition and disconnect the
battery.
2
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Connect the wiring harness wires in the
following order: ground, battery, ignition.
5
Connect the wiring harness connector to
the unit.
6
Install the unit in your car.
• Make sure that the unit is installed securely
in place. If the unit is unstable, it may
malfunction (eg, the sound may skip).
7
Reconnect the
8
Press the reset button.
9
Configure <Initial Setup>. (Page 4)
·
· battery.

Installing the unit

Installing the unit using the mounting
bracket removed from the car
4* or 5
• Select the appropriate type of screw for the
mounting bracket: flat head (4)* or round head
(5).
* Supplied only for DDX6015BT/DDX4015BT/DDX415BT/DDX415BTM/
DDX315/DDX315M.
Installing the trim plate (Only for
DDX4015BT)
1
Attach the trim plate ( ).
2
Car Bracket
4* or 5
2
ENGLISH 51