Zanussi ZWH 6100P User Manual page 25

Malfunction
Spinning starts late or the ap-
pliance does not spin:
No water is visible in the
drum:
Unsatisfactory washing re-
sults
The appliance makes an un-
usual noise
After completing these checks, switch on the appliance
and press the button 6 to restart the programme.
Mod. ... ... ...
Prod. No. ... ... ...
The electronic unbalance detection device has cut in because the laundry is not even-
ly distributed in the drum. The laundry is redistributed by reverse rotation of the
drum. This may happen several times before the unbalance disappears and normal
spinning can resume. If, after 10 minutes, the laundry is still not evenly distributed in
the drum, the appliance will not spin. In this case, redistribute the load manually and
select the spin programme.
• Load more laundry.
The load is too small.
• Add more items, redistribute the load manually and then select the spinning pro-
gramme.
Appliances based on modern technology operate very economically using very little
water without affecting performance.
Too little detergent or unsuitable detergent has been used.
• Increase the detergent quantity or use another one.
Stubborn stains have not been treated prior to washing.
• Use commercial products to treat the stubborn stains.
The correct temperature was not selected.
• Check if you have selected the correct temperature.
Excessive laundry load.
• Reduce the laundry load.
The appliance is fitted with a type of motor which makes an unusual noise compared
with other traditional motors. This new motor ensures a softer start and more even
distribution of the laundry in the drum when spinning, as well as increased stability of
the appliance.
Ser. No. ... ... ...
Possible cause / Solution
If the malfunction shows again, contact your Service Cen-
tre. The necessary data for the service centre is on the rat-
ing plate. We recommend that you write the data here:
Model description (MOD.) ........................................
Product number (PNC) .............................................
Serial number (S.N.) .................................................
25