Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZWH 6100P
Summary of Contents for Zanussi ZWH 6100P
- Page 1 User manual Washing Machine ZWH 6100P ZWH 6120P...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Frost precaution _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Environment concerns _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4... - Page 3 not pressing the electrical supply cable against the • The detergent dispenser drawer is provided with an in- wall. sert for liquid detergent. Do not use the insert down- wards for gelatinous detergents, with programmes in- • Install the appliance on a flat hard floor. cluding prewash, with the delay start option.
-
Page 4: Frost Precaution
To activate this device, ro- To disable this device and tate the button (without restore the possibility of pressing it) inside the closing the door, rotate the door clockwise until the button anti-clockwise until groove is horizontal. If the groove is vertical. necessary use a coin. -
Page 5: Product Description
Worktop Drain hose support Control panel Hose holders Door opening handle Water inlet hose Rating plate (on the inner edge) Mains cable Front adjustable feet Back feet ZWH 6100P = 2 front adjustable feet ZWH 6120P = 4 adjustable feet... -
Page 6: Technical Data
0,05 MPa Maximum 0,8 MPa Maximum Load Cotton 7 kg Spin Speed Maximum 1000 rpm (ZWH 6100P) 1200 rpm (ZWH 6120P) Installation Unpacking • Remove the external film. Use a cutter, if Warning! necessary. • Read carefully the "Safety information" chapter before installing the appliance. - Page 7 • Return appliance to it's • Unscrew the three bolts (A) and remove the hose upright position. holders (C). • Slide out the relevant plastic spacers (B). Warning! Do not re- move the drain hose from the rear support. Re- move this hose only if it is necessary to drain the wa- •...
- Page 8 Positioning and levelling Water inlet Connect the hose to a tap with a 3/4” thread. 35° 45° Loosen the ring nut to angle the hose to the left or right Level the appliance by raising or lowering the feet. De- depending on the position of your water tap.
- Page 9 If the outlet spigot has not been used before, remove any blanking plug that may be in place. • Directly into a drain pipe at a height of not less than 60 cm and not more than 100 cm. The end of the drain hose must always be ventilated, i.e.
-
Page 10: Special Accessories
Electrical connection • Make sure that the mains plug and cable is not squashed or damaged by the back of the appliance. • The appliance must be earthed. • Make sure that the mains plug is accessible after in- • Make sure that the electrical information on the rating stallation. - Page 11 Mould stains: treat with bleach, rinse well (whites and fast Close the door gently coloureds only). Grass: soap lightly and treat with bleach (whites and fast Warning! Make sure coloureds only). that any fabrics were not trapped when closing Ball point pen and glue: moisten with acetone , lay the the door.
- Page 12 If the water hardness degree is medium or high we sug- • Remove the drawer. Push the drawer edge outwards gest you to add a water softener following always the where indicated by the arrow (PUSH) to facilitate manufacturer’s instructions. drawer removal.
- Page 13 Measure out the fabric softener Warning! Do not use the flap in "DOWN" position with: Pour fabric softener or any • Gelatinous detergent or thick detergent. additives into the compart- • Powder detergent. ment marked (do not • With programmes with prewash. exceed the «MAX»...
- Page 14 Programme selector dial Turn the programme selector dial to the required programme. The selector dial can be turned either clockwise or counter-clockwise. The green pilot light of the button 6 starts flashing: the appliance is now switched on. If you turn the programme selector dial to another programme when the appliance is working, the red pilot light of the button 6 will flash 3 times to indicate a wrong selection.
- Page 15 Extra Rinse This appliance is designed for saving water. However, for people with very delicate skin (allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of water. Press simultaneously the buttons 3 and 4 for some seconds: the pilot light 7.2 comes on.
- Page 16 If the door remains locked, this means that the appliance is already heating or that the water level is too high. In any case, do not try to force the door open! If you cannot open the door but you need to open it you have to switch the appliance off by turning the selector dial to .
-
Page 17: Washing Programmes
RINSE HOLD, Prewash - Main wash - Rinses - Maximum spin speed at: 1000 rpm DELAY START, for model ZWH 6100P; 1200 rpm for model ZWH 6120P SUPER QUICK Max. load 7 kg - Reduced load 3,5 kg EXTRA RINSE White, coloured cotton and linen. - Page 18 40°- (Cold) Main wash - Rinses - Maximum spin speed: at 1000 rpm for model AUTOMATIC SPIN RE- ZWH 6100P; 1200 rpm for model ZWH 6120P DUCTION, Max. load 2 kg RINSE HOLD, Machine washable wool, hand washable woollens and delicate fab- DELAY START rics with «hand washing»...
-
Page 19: Consumption Values
60°- Cold AUTOMATIC SPIN RE- Main wash - Rinses - Maximum spin speed at: 1000 rpm for model DUCTION, ZWH 6100P; 1200 rpm for model ZWH 6120P RINSE HOLD, Max. load 3 kg DELAY START Trousers, shirts or jackets in denim and jersey realized with hi-tech materials. -
Page 20: Care And Cleaning
The actual water temperature may differ from the de- clared cycle temperature. Care and cleaning Warning! Switch the appliance off and remove the mains plug from the socket before any cleaning action. Maintenance Wash With the use of low temperature washes it is possible to get a build up of residues inside the drum. - Page 21 • turn the drum and align the filter cover (FILTER) with the arrow on the door seal; • open the filter cover by pressing the special hook and by rotating the cover upwards; Warning! Keep the filter cover open un- til the filter removal.
-
Page 22: What To Do If
• Screw the hose back onto the tap. Make sure the • Screw the hose back to the appliance and make sure connection is tight. the connection is tight. • Turn on the water tap. • Unscrew the hose from the appliance. - Page 23 Fault code and malfunction Possible cause / Solution The drain hose is squashed or kinked. • Check the drain hose connection. The drain filter is clogged. If the appliance stops working without discharging the water , first carry out an emer- gency drain: •...
- Page 24 Malfunction Possible cause / Solution The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. The appliance does not start: •...
- Page 25 Malfunction Possible cause / Solution The electronic unbalance detection device has cut in because the laundry is not even- ly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume.
- Page 28 www.zanussi.com/shop...