Zanussi ZWH 6100P User Manual page 15

Extra Rinse
3
+
4
Delay Start
5
Start/Pause
6
This appliance is designed for saving water. However, for people with very
delicate skin (allergic to detergents) it may be necessary to rinse the laundry
using an extra quantity of water.
Press simultaneously the buttons 3 and 4 for some seconds: the pilot light
7.2 comes on. This function stays permanently on. To remove it press the
same buttons again until the pilot light 7.2 goes off.
The start of the programme can be delayed by 9, 6 or 3 hours by means of
this button. The relevant light illuminates.
You must select this option after you have set the programme and before
you start the programme.
Select a delayed start:
• select the programme and the required options;
• select the delay start by pressing the button 5;
• press the button 6:
– the appliance starts its hourly countdown.
– The programme will start after the selected delay has expired.
Cancelling the delayed start after having started the programme:
• set the appliance to PAUSE by pressing the button 6;
• press the button 5 once, the light relevant to the selected delay goes off;
• press the button 6 again to start the programme.
The DELAY START cannot be selected with the drain programme.
Important! The selected delay can be changed only after selecting the wash-
ing programme again. The door will be locked throughout the delay time. If
you need to open the door, you must set the appliance to PAUSE (by press-
ing the button 6) and then wait a few minutes. After you have closed the
door, press the button 6 again.
Start the programme by pressing the button 6
• To start the selected programme, press the button 6, the corresponding
green pilot light stops flashing. The pilot light 7.1 illuminates to indicate
that the appliance starts operating and the door is locked. If you have
chosen a delayed start, the appliance will begin the countdown.
• To interrupt a programme which is running, press the button 6: the corre-
sponding green pilot light starts flashing. It is possible to change some
options of a running programme before the programme carries them out.
• To restart the programme from the point at which it was interrupted, press
the button 6.
• After the programme has started the door is locked. If, for any reason, you
need to open the door, set firstly the appliance to PAUSE by pressing the
button 6. After a few minutes it will be possible to open the door.
15