Table of Contents
Advertisement
2
Hookup
2.1
Rear-Panel Connections and Controls
2
Hookup
2.1
Rear-Panel Connections and Controls
2.1.1 Inputs
2.1.2 Outputs
Line-level Inputs: The Temblor T10 provides a choice of three input pairs: two sets
of balanced inputs (XLR and ¼" TRS) and one pair of RCA unbalanced inputs. When
both of the balanced connections are in use, the TRS inputs will take precedence
over the XLR inputs. The RCA inputs will sum into either balanced connection.
Power User Tip: Connect both the left and right inputs if you are using the onboard
crossover in your Temblor T10 to connect your full-range monitors or if you're running
your Temblor T10 independently from a stereo source (such as the Monitor Station
or Central Station). This will ensure that your Temblor T10 receives the low-frequency
content from both channels. If your audio source provides a mono or LFE output, you only
need to connect one input—either L or R.
2
1
[+]
Ground
3
[-]
XLR
TRS
Input Gain: Sets the level of the input signal before it is amplified.
Outputs: The Temblor T10 provides two pairs of balanced outputs: XLR and ¼"
TRS. The full-range signal connected to the stereo inputs on the T10 is passed
through to these outputs. Use these outputs to connect your main left and
right studio monitors. If the High Pass Filter switch is engaged, frequencies
below 80 Hz are not sent from these outputs.
Sub Out: This XLR Output sends the summed full-range input signal to a second
Temblor T10. When connecting a second T10 to this output, set its Low Pass Filter
control to the same setting as the first.
Sleeve:
Ring:
Tip:
Ground
[-]
[+]
Temblor-T10
Owner's Manual
3
Advertisement
Table of Contents
