Table of Contents
Advertisement
42 Timer Recording With the VCR Plus+ Programming System
Follow the steps below to program a timer recording using the
PlusCode programming numbers in your TV guide. Before you
begin, make sure:
Channels are programmed (page 12).
The VCR Plus+ and Cable/TV channel numbers are entered
(pages 40 - 41).
The clock is set (pages 14 - 17).
There is a tape in the VCR. Make sure the tape's record tab is
intact and the tape is long enough to record the program(s).
The VCR power is on and the VCR light appears on the display
panel of the VCR. If it does not, press the VCR/TV button
once.
Complete each step within 60 seconds of completing the
previous step. If you don't, you may return to step 1.
1
Press the VCR button.
2
Press the VCR PLUS+ /ENTER button on the remote con-
trol. The on-screen display shown below will appear.
VCR PLUS+ PROG.
PLUS CODE : – – – – – – – –
TO END PUSH EXIT
3
Press the Number buttons to enter the PlusCode pro-
gramming number of the program you wish to record (this
number is different for every program, and it can be four to eight
digits long). Finally, press the VCR PLUS+ /ENTER button.
VCR PLUS+ PROG.
PLUS CODE : 13285 – – –
TO SET PUSH VCR +
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
4
To record the program once, press the Number 1 button
to select ONCE. To record the same program every day
from Monday through Friday, press the Number 2 button
to select DAILY. To record the same program every week
on the same day (such as every Saturday), press the
Number 3 button to select WEEKLY.
VCR PLUS+ PROG.
1 ONCE
2 DAILY
3 WEEKLY
TO SELECT PUSH NO. SHOWN
TO END PUSH EXIT
1
CBL/DSS
VCR
TV
POWER
VCR PLUS+
PAUSE
/ENTER
/STILL
SLOW
F.ADV
STATUS/EXIT
CLEAR
MENU
V
C
VOL
CH
4
V
C
1
2
3
4
5
6
7
8
9
100
0
A.CH
INDEX
SKIP
REC/OTR
SEARCH
SEARCH
VCR/TV
SPEED
MEMORY
EJECT
X2 PLAY
VAR.SLOW
TRACKING
MUTE
TIME SEARCH REC END SEARCH
JOG & SHUTTLE
Helpful Hints
• If CODE ERROR flashes after you
enter the PlusCode programming
number and press the VCR
PLUS+/ENTER button, the number
you entered was incorrect (for exam-
ple, too short). If this happens, enter
the correct number.
• CLASH may flash on the screen at
step 3. This means that the timer
recording you just programmed and
another timer recording overlap, and
thus the current timer recording will
not be carried out.
2
3
Advertisement
Table of Contents
