Security Operation Active Arming: Lock And Arm - Marksman X11 Owner's Manual

Manual Arming: Lock and Arm
1. Press the button on the transmitter.
2. The siren will chirp once and parking lights will flash once indicating that the system is now
armed. The vehicle door will lock upon arming when interfaced with the security system.
System Armed
ARM
Door Ajar / Defective Sensor Reminder
If the siren sounds 3 times, there is a Door, Trunk, or Hood left open.
Silent Arming/Disarming
Pressing the transmitter
system, No chirp sound will be heard, arm/disarm confirmation will be through the vehicles
parking lights only.
Shock Sensor Bypass (Sensor #1)
Press the button on the transmitter two times within 3 seconds. This will arm the security
system and bypass the shock sensor.
Sensor Bypass (Sensor #2)
Press the button first, within 3 seconds, press the
the security system and bypass the #2 sensor.
All Sensor Bypass (Sensor #1 and #2)
Press the button first, within 3 seconds, press the
will arm the security system and bypass both electronic sensor ports.
Notes on Remote Sensor Bypass: The sensor bypass feature is programmed to activate for one
arming cycle only. The security system will return to normal operation during the next arming cycle.
Automatic Arming
This security system is equipped with an optional automatic arming feature which allows the
security system to arm 30 seconds after the last door is closed. Operation is as follows:
1. Turn the ignition to the "OFF" position and exit the vehicle.
2. After all entrances are closed, the security system LED will flash fast for 30 seconds. If you re-
open any protected entrance, the security system LED will stop flashing. It will begin flashing
again once the vehicles entrances are closed.
3. After the 30-second timer has elapsed, the security system will automatically "ARM". The
siren/horn will chirp once and the parking lights will flash once.
Door Ajar
ARM
and button at the same time will arm or disarm your security
(Applies only when Automatic Arming is Programmed On)
Trunk/Hood Ajar
ARM
button on the transmitter. This will arm
button on the transmitter (2) times. This
Clear the Flash Icon:
Press the SET button 3 times
within 3 seconds to clear the
flash icon on the LCD screen
transmitter.
7