Connecting The Cords - JUKI MF-7500 series Instruction Manual

(2) connecting the cords

1
A
1) Pass cords 1 of the thread trimming solenoid,
reverse-stitching solenoid, etc. and the cord from
the motor through hole A in the table to route them
down under the machine table.
!0
9
7) Insert pedal sensor cable !1 into connector !2 (CN34).
8) Insert motor fan cord !3 into connector !4 .
Be sure to securely insert the respective connectors after checking the inserting directions since all con-
nectors have the inserting directions. (When using a type with lock, insert the connectors until they go to
the lock.) the sewing machine is not actuated unless the connectors are inserted properly. In addition, not
only the problem of error warning or the like occurs, but also the sewing machine and the control box are
damaged.
[connecting the connector for the operation panel]
!5
8 !2
5
!1
3
!6
B
2) Loosen screw B in cover 2 with a screwdriver to
open the cover.
6 7 !4
!3
4
The connector for the operation panel is provided.
Paying attention to the orientation of the connector !5 ,
connect it to connector (CN38) !6 located on the circuit
board. After the insertion, securely lock the connectors
to prevent them from coming off easily.
Be sure to turn oFF the power before connect-
ing the connector.
–  –
2
3) Connect 14P code 3 coming
from the machine head to con-
nector 6 (CN36).
4) Insert 3P cord 9 coming from
the machine head into connec-
tor !0 (CN42).
5) Insert presser foot lifter cord 2P
4 into connector 7 (CN37).
6) Connect connector 5 coming
from the motor to connector 8
(CN30) on the circuit board.