Getting Started; Before You Begin Cleaning - Vax MACH PET Let's Get Started

PLEASE READ 'LET'S TALK SAFETY' AT THE BEGINNING BEFORE USE

Before you begin cleaning

• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or removing
and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the thermostat
will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug from electrical
socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum cleaner to
cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters to fully dry before putting
back into the vacuum).
• Pre-motor filter requires cleaning at least every 3 months.
• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.
• When using the accessories always make sure the brushbar is switched to the off position.
IMPORTANT: The base of the vacuum cleaner should always be positioned flat on the floor when starting and in use.
The dirt container should be locked into place before lifting the vacuum cleaner by the carry handle.
Assembling your machine
IMPORTANT: The condition of the filters affects the performance of your machine. Please check and clean filters
periodically (depending on the level of use). For full cleaning instructions, see 'Taking care of your machine'.
Insert the end of the hose
into the unit. Ensure the
hose has clicked into place.
Insert handle into
telescopic extension tube.

Getting started

Press button on telescopic
extension tube and adjust
to required length.
Insert the other end of
the telescopic tube into
the floorhead until it clicks
into place.