Table of Contents
Advertisement
1.1.
GAS TESTING AND CERTIFICATION AND CE MARK
These boilers have been tested and certified for safety and performance. It is important that no alteration is
made to the boiler unless it is approved in writing by Gledhill Ltd.
The boiler meets the requirements of Statutory Instrument No 3083 i.e. 'The Boiler (Efficiency) Regulations'
and therefore it is deemed to meet the requirements of Directive 92/42/EEC. The product has been certified
by the Notified body Advantica 0087 and the production is certified by the notification body BSI 0086.
The CE mark on this appliance shows compliance with:
(a) Directive 90/396/EEC on the approximation of laws relating to appliances burning gaseous fuels.
(b) Directive 73/23/EEC on the harmonisation of laws of the Member States relating to electrical equipment
designed for use within certain voltage limits.
(c)
Directive 89/336/EEC on the approximation of the laws of Member States relating to electromagnetic
compatibility.
1.2.
SPARE PARTS
When replacing spare parts on this appliance, remember to use only spare parts that you can be assured to
conform to the safety and performance specification that we require. Do not use reconditioned or copy parts
that have not been clearly authorised by Gledhill Ltd.
1.3.
HANDLING AND STORING THE APPLIANCE
This appliance should be handled carefully to avoid damage and any manual handling/lifting operations will
need to comply with the requirements of the Manual Handling Operations Regulations issued by the H.S.E.
During the appliance installation it will be necessary to employ caution and assistance whilst lifting as the
appliance or component exceeds the recommended weight for a one man lift.
Take care to avoid trip hazards, slippery or wet surfaces. In certain situations it may be necessary to use
mechanical handling aids.
If the unit needs to be stored prior to installation it should be stored upright in a dry environment and on a
level base.
1.4.
SYSTEM INSTALLATION
Any installation must be in accordance with the relevant requirements of the current issue of Gas Safety
(Installation and Use) Regulations, Local Building Regulations, Local Water Company Bylaws and Health &
Safety Document No. 635 – The Electricity at Work Regulations 1989. The detailed recommendations are
contained in the current issue of the following British Standards and Codes of Practices: -
BS 5440 Pts. 1 & 2; BS 5449; BS 5546; BS 7074 Part 1; BS 6700; BS 6798; BS 6891, BS 7593,
IGE/UP/7/1998
1.5.
WARNINGS
(a) Gas Leak or Fault
If a gas leak or fault exists or is suspected, turn the boiler mains electricity supply off and turn off the
gas supply at the meter. Consult your local gas company or your local installation/servicing company.
VER: 02.3 _260505
1. IMPORTANT INFORMATION
Page:3/41
Advertisement
Table of Contents
