Mercedes-Benz CLK 320 Operator's Manual page 206

Caution!
Never change the program mode when the selector lever
is out of position "P". It could result in a change of
driving characteristics for which you may not be
prepared.
Important!
Always be certain of the program mode selected since
the vehicle driving characteristics change with the
selection of the program mode.
Dependent on the program mode selector switch
position "S" or "W" and the gear selector lever in
position "R", the ratio of power transmission changes.
Emergency operation (Limp home mode)
If vehicle acceleration worsens or the transmission no
longer shifts, the transmission is most likely operating
in Limp home mode which engages when there is a
malfunction of the transmission. This condition may be
accompanied by the "CHECK ENGINE" malfunction
indicator lamp in the instrument cluster coming on.
Automatic transmission
Instruments
Operation
and controls
Instrument
Driving
cluster display
In this mode only the 2nd gear or reverse gear can be
activated.
To engage 2nd gear or reverse:
1. Stop the vehicle.
2. Move selector lever to position "P".
3. Turn off the engine.
4. Wait approx. 10 seconds.
5. Restart the engine.
6. Move selector lever to position "D" (for 2nd gear), or
move selector lever to position "R" (for reverse gear).
Have the transmission checked at your authorized
Mercedes-Benz Center as soon as possible.
203
Practical hints Car care
Technical
Index
data