Table of Contents
Advertisement
Okayo Portable PA System
Transmitter Operation
All portable PA's equipped with a UHF wireless microphone module are compatable with the C 7192B handheld and
C 7195B beltpack transmitters. All transmitters are sold separately.
C 7192B Handheld Microphone Transmitter.
1. Ensure microphone is switched off before inserting batteries.
2. Remove lower housing and battery clip. Insert two AA batteries (alkaline or rechargeable's are recommended).
3. Press and hold the power switch for three seconds (located on the base of the microphone). The power LED will
illuminate red and "ON" will be displayed on the LCD screen. Note: power switch is more easily accessed with lower
housing removed.
4. A selection switch on the rear of the microphone provides three level settings (mute, mid & high) depending on the
application or environment in which the portable PA is to be used. Mute setting allows microphone to be put on
standby without switching the power off.
5. The LCD screen will display the channel selected. To determine which frequency this channel is operating on, press
the UP or DOWN frequency adjustment buttons.
6. Press the frequency set button for two seconds. The LCD screen will flash the currently selected channel number.
You can cycle through the channels by pressing the UP or DOWN frequency adjustment buttons. Press the frequency
set button again to lock in your channel selection.
7. The battery status is displayed on the left of the screen. When battery capacity is critical the icon will flash three
times before switching the microphone off automatically.
8. To turn the microphone off press the power switch for three seconds until the LCD screen displays "OFF"
9. When using with rechargeable NiMH batteries, connect a DC 5V plugpack (Altronics M 8909A plus M 9187 tip
adaptor) to the charging port on the base of the microphone. Charging time is dependant on the capacity of
batteries used, typically 10-12 hours charging is required. If battery icon is flashing when charger is connected,
ensure rechargeable batteries are inserted in the microphone. If batteries have failed both the battery icon and
screen backlight will flash.
During normal charging the battery icon will cycle through the charge "block" icons. Once full capacity is reached
the full battery icon and all "blocks" will be displayed.
Note: microphone is unable to be used during charge process.
C 7195B Beltpack Transmitter.
1. Ensure microphone is switched off before inserting batteries.
2. Remove battery clip. Insert two AA batteries (alkaline or rechargeable's are recommended).
3. Switch the top mounted power switch to ON. The power LED will illuminate red and "ON" will be displayed on the
LCD screen.
4. A selection switch on the side of the beltpack provides three level settings (low, mid & high) depending on the appli-
cation or environment in which the portable PA is to be used. The mute button allows beltpack to be put on standby
without switching the power off.
5. The LCD screen will display the channel selected. To determine which frequency this channel is operating on, press
the UP or DOWN frequency adjustment buttons.
6. Press the frequency set button for two seconds. The LCD screen will flash the currently selected channel number.
You can cycle through the channels by pressing the UP or DOWN frequency adjustment buttons. Press the frequency
set button again to lock in your channel selection.
7. The battery status is displayed on the left of the screen. When battery capacity is critical the icon will flash three
times before switching the microphone off automatically.
8. When using with rechargeable NiMH batteries, you can use the C 7196 charging pod. This allows you to put up to
two beltpacks on charge at the same time. Charging time is dependant on the capacity of batteries used, typically
10-12 hours charging is required. If battery icon is flashing when charger is connected, ensure rechargeable batter-
ies are inserted in the microphone. If batteries have failed both the battery icon and screen backlight will flash.
During normal charging the battery icon will cycle through the charge "block" icons. Once full capacity is reached
the full battery icon and all "blocks" will be displayed.
Okayo Portable PA System
7
Advertisement
Table of Contents
