Dvd/Cd/Video Cd Player - Pioneer S-DV323 Operating Instructions Manual

Additional information
Problem
Sound Demo shows in
the display and the unit
can't be controlled.
Timer indicator is
blinking and the
system will not switch
on.

DVD/CD/Video CD player

Problem
The disc is ejected
automatically after
loading.
Playback is not
possible.
Picture playback stops
and the operation
buttons cannot be
used.
Settings are canceled. • When the power is cut due to power failure or by unplugging the power
No picture/No color.
Screen is stretched or
aspect does not
change.
When recorded on a
VCR or passed through
an AV selector, there is
disturbance in the
playback picture.
Remedy
• Press and hold (stop) on the front panel for about five seconds. The disc
tray ejects automatically to indicate the Sound Demo mode is disabled.
• Unplug the unit, then plug back in. Wait for one minute then switch on.
• Make sure the fan at the rear of the unit is not being blocked.
• Check that the speakers are connected correctly.
• Make sure the voltage of the mains power source is correct for the model.
• If the problem persists, take it to your nearest Pioneer
authorized service center or your dealer for servicing.
Remedy
• Clean the disc.
• Align the disc properly in the disc guide.
• If the region number on a DVD-video disc does not match the number on
the player, the disc cannot be used (see DVD Video regions on page 61).
• Allow time for any condensation inside the player to evaporate. Avoid using
the player near an air-conditioning unit.
• If the disc is loaded upside down, reload the disc with the label side face
up.
• Press (stop), then
• Switch the power off once, then on again using the front panel
STANDBY/ON
button.
cable, settings will be canceled.
• Check that connections are correct and that plugs are inserted fully.
• Check the instruction manual of the TV/monitor to make sure the TV/
monitor settings are incorrect.
• The TV Screen setting is incorrect. Set the TV Screen option to match the
TV/monitor you're using (see Video Output settings on page 49).
• This system uses copy-protection technology which may prevent recording
or cause picture problems when connected through a VCR or AV selector.
This is not a malfunction.
(play) to start playback again.
13
65
En