Table of Contents
Advertisement
3. S
ETUP
AC Power
Fuse
Replacement
Power Linking
Power Linking
Diagram
SlimBEAM™ QUAD IRC User Manual Rev. 1
The SlimBEAM™ QUAD IRC has an auto-ranging power supply and it can work with an
input voltage range of 100 to 240 VAC, 50/60 Hz. To determine the product's power
requirements (circuit breaker, power outlet, and wiring), use the current value listed on the
label affixed to the product's back panel, or refer to the product's specifications chart. The
listed current rating indicates the product's average current draw under normal conditions.
·
Always connect the product to a protected circuit (circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or
fire.
·
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
1.
Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
2.
Pry the fuse holder out of the housing.
3.
Remove the blown fuse from the holder and replace with a fuse of the exact same
type and rating.
4.
Insert the fuse holder back in place and reconnect power.
Spare fuse holder
(inside safety cap)
Disconnect the product from the power outlet before replacing the fuse.
The product provides power linking via the Edison outlet located in the back of the unit.
Please see the diagram below for further explanation.
You can power link up to 18 SlimBEAM™ QUAD IRC units on 120 VAC or up to
34 SlimBEAM™ QUAD IRC units on 230 VAC.
The power linking diagram corresponds to the North American version of the product
ONLY! If using the product in other markets, you must consult with the local Chauvet
distributor as power linking connectors and requirements may differ in your country or
region.
Installed fuse
(held by plastic clip)
Safety cap
st
1
Product
nd
2
Product
rd
3
Product
Additional
Products
Page 7 of 19
Advertisement
Table of Contents
