Qlogic iSR6200 Quick Start Manual page 5

Step 2. Complete the Pre-Installation Checklist
During the initial configuration process, the system prompts you to enter information for each blade contained in the
iSR6200. Use the spaces provided in the following tables to record the IP addresses for each blade.
Symbolic name of the iSR6200 Blade 1
mask, and gateway (if not using DHCP)
iSCSI port 1 IP address, subnet mask,
and gateway (GE-1)
IP address of the Internet simple name
service (iSNS) server for iSCSI port 1 (if
iSNS will be enabled)
iSCSI port 2 IP address, subnet mask,
and gateway (GE-2)
IP address of the iSNS server for iSCSI
port 2 (if iSNS will be enabled)
iSCSI port 3 IP address, subnet mask,
and gateway for the optional (FC3, GE-3,
or 10GE-3) port
IP address of the iSNS server for iSCSI
port 3 (if iSNS will be enabled)
iSCSI port 4 IP address, subnet mask,
and gateway for the optional (FC4, GE-4,
or 10GE-4) port
IP address of the iSNS server for iSCSI
port 4 (if iSNS will be enabled)
Symbolic name of the iSR6200 Blade 2
Management port IP address, subnet
mask, and gateway (if not using DHCP)
iSCSI port 1 IP address, subnet mask,
and gateway (GE-1)
IP address of the iSNS server for iSCSI
port 1 (if iSNS will be enabled)
iSCSI port 2 IP address, subnet mask,
and gateway (GE-2)
IP address of the iSNS server for iSCSI
port 2 (if iSNS will be enabled)
Table 1. Worksheet for Router Blade 1 (left) Parameters
Table 2. Worksheet for Router Blade 2 (right) Parameters
5