Identification Of Controls; Front Panel; Standby Button; Standby Led - NAD CI940 Owner's Manual

IDENTIFICATION OF CONTROLS

FRONT PANEL

Multi-Channel Amplifier CI 940
1 2

1 STANDBY BUTTON

· Press this button to switch ON the CI 940. The Standby LED indicator
will turn from amber to blue.
· Pressing the Standby button again turns the unit back to standby
mode.
IMPORTANT NOTICE
The rear panel POWER switch must be in the ON position for the Standby
button to activate.

2 STANDBY LED

·
This indicator will light up amber when the CI 940 is in standby
mode. When the CI 940 is powered up from standby mode, this
indicator will illuminate blue.
· At auto sense mode, this indicator will stay blue for about 10
minutes after any active input signal is shut down and then
eventually turns amber at standby mode.
3 ZONE 1, ZONE 2
· Both indicators will light up blue whenever there is an active input
signal or source connected at either ZONE 1 or ZONE 2 INPUT
terminals.
·
These indicators will extinguish (no light) in the absence of active
input signal or source connected at both ZONE 1 and ZONE 2 INPUT
terminals.
6
3
© NAD CI940