Debug Mode; Audio Debug Mode; To Set In Debug Mode - Onkyo TX-NR717 Service Manual

DEBUG MODE-1

AUDIO DEBUG MODE-1/4

AUDIO DEBUG MODE (Display mode of the audio information)
The operations of DSP and DIR etc are able to checked by the information displayed on FL in this debug mode.
This information will help to analysing digital audio no sound trouble.

To set in Debug mode

1. Press and hold down DISPLAY button, then press ON/STANDBY button.
e.g.
2. Press + (TONE) button while the version number of microprocessor is displayed.
e.g.
3. Press DISPLAY button while the version number of DSP is displayed.
e.g.
0A0002:
ANA: o: NON:
4. Press DISPLAY button.
e.g.
1: ANA 0 48k0 48k
2/ 0 . 0 : 2 . 0 : 3/ 4
5. Press DISPLAY button.
e.g.
2: o : PCM : PC M
00 : x: F : OF F
6. Press DISPLAY button.
e.g.
SP00F 0 0F0 040 9
*
48 48256S T B
7. Press DISPLAY button.
e.g.
L : 0 0
R : 0 0
8. Press DISPLAY button.
e.g.
C : 0 0
9. Press DISPLAY button.
e.g.
LS : 0
R S : 0
TX-NR717
ON/STANDBY + (TONE)
M ai n:
1. 02 / 126 11A H
DSP 1st / NE T:
1. 02 /1 260 8A HA
: 0 0 Audio dubug mode
Step-1
:
Step-2
Step-3
Step-4
Step-5
Step-6
Step-7
0
0
DISPLAY
TX-NR717/818/1010/3010/5010
The version number of microprocessor is displayed
only for 3 seconds.
The version number of DSP is displayed
only for 3 seconds.
10. Press DISPLAY button.
e.g.
L B : 0 0
R B : 0 0
11. Press DISPLAY button.
e.g.
L H : 0 0
R H : 0 0
12. Press DISPLAY button.
e.g.
L W : 0 0
R W : 0 0
13. Press DISPLAY button.
e.g.
S W : 0 0
S W2 : 0 0
14. Press DISPLAY button.
Exit
TX-NR818/1010/3010/5010
ON/STANDBY + (TONE) DISPLAY
Step-8
Step-9
Step-10
Step-11