Spray Pattern - Titan CAPSPRAY 55 Training Manual

Maxum II and Maxum Elite Air Cap Adjustments
Air Cap

Spray Pattern

The Fan Size
CAPSPRAY's exclusively designed guided air cap makes it virtually
impossible for the painting contractor to misalign. This translates to better
spray pattern control.
The air cap design determines the quality of the spray pattern. It is crucial the
air cap remains clean and free of dried paint.
The CAPSPRAY HVLP gun offers a choice of three spray patterns: horizontal
flat, vertical flat and round. To select the desired pattern, simply rotate the
two air cap "ears" until they click into the desired position.
An up and down position gives you a horizontal pattern. When the ears are
side by side, you will get a vertical pattern. And when the ears are diagonal,
the pattern is round. Never trigger the gun while adjusting the spray pattern.
Diagonal Round Spray
Cap Position Pattern
To change fan size, change the distance from the
surface to the gun nozzle. The closer you are to
the surface, the smaller the pattern becomes.
Moving back increases the fan size.
Trigger pull will also vary the fan size.
The greater the trigger pull, the greater
the material flow and fan size.
Another way to adjust fan size is to move the
air cap in (clockwise) for a larger pattern or out
(counter-clockwise) for a smaller pattern.
When getting started, the air cap should be flush
with the fluid nozzle. This will give you the full
range of pattern size control.
1 0
Horizontal Vertical Spray
Cap Position Pattern
adjustable from
Vertical Horizontal Spray
Cap Position Pattern
Larger
Larger
pattern
pattern
Smaller
Smaller
pattern
pattern
Spray pattern width is
/ " to 12".
1
4