Kenwood HM620 series Instructions Manual page 3

Only use the appliance for its intended
G
domestic use. Kenwood will not accept any
liability if the appliance is subject to improper
use, or failure to comply with these
instructions.
before plugging in
Make sure your electricity supply is
G
the same as the one shown on the
rear of your handmixer.
Important – UK only
The wires in the cord are coloured
G
as follows:
Blue = Neutral, Brown = Live.
The appliance must be protected by
G
a 3A approved (BS1362) fuse.
Note:
For non-rewireable plugs the fuse
G
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut off it
G
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
This appliance conforms to EC
G
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
before using your handmixer
for the first time
Wash the parts (see 'cleaning').
G
key
speed switch
tool release button
beaters
cord wrap
kneader with small collar
kneader with large collar
beater storage pillars
kneader storage pillars
worktop storage unit
cord tidy
to use your handmixer
1 Unwrap the cord from the cord
wrap and make sure the speed
switch is in the off "O" position.
2 Insert the beaters or kneaders
turn and push until a positive click is
felt.
Important: The kneader with the
small collar
larger socket.
3 Plug in.
4 With the ingredients in a bowl of an
appropriate size, place the
beaters/kneaders into the bowl.
5 Pull the speed switch backwards to
reach the desired speed (the first
dot on the handmixer body is the
slowest speed setting). Line up the
dot on the side of the speed switch
with the corresponding speed.
As the mixture thickens, increase
G
the speed.
If the machine starts to slow or
G
labour, increase the speed.
Move the speed switch forwards to
G
the pulse "P" position to operate the
motor at maximum speed. The
motor will operate for as long as the
pulse is held in position.
6 When the mixture has reached the
desired consistency, return the
speed switch to the off "O" position
and then lift the beaters/kneaders
out of the bowl.
3
will only fit into the
–