Advertisement
ASSEMBLY INSTRUCTIONS
1. Attach the column to the stand with the 4 screws as
shown.
2. Loosen and take off the height adjustment nut.
3. Slide the stand cover down the column to rest on the
stand.
4. Pull out the extension tube to a required height and
tighten the height adjustment nut.
Caution: The height adjustment nut must be fully
tightened before assembling the motor section to the
pedestal stand.
5. Fit the motor section to the pedestal stand and tighten
the thumbscrew.
Caution: The thumbscrew must be fully tightened
before the fan is operated.
6. Set the rear guard in the proper position (handle
uppermost) and screw on the guard retaining nut until
it is tight.
7. Mount the blade onto the shaft and tighten with the
blade retaining nut (counter-clockwise) firmly.
8. Open clips on the front guard and attach front guard
with rear guard (align locking screw holes).
9. Secure both guards firmly by fitting and tightening the
screw and nut.
OPERATING INSTRUCTIONS
1. Operate the control panel button for the required fan speed. '0' for 'OFF', '1' for Low
Speed, '2' for Medium Speed and '3' for High Speed.
2. To make the fan head oscillate, push the oscillating knob DOWN. To stop the
oscillation, pull the oscillating knob UP.
WARNING: Do not adjust the oscillating angle by hand. It will damage the
synchronous motor.
3. To adjust the tilt of the fan head, loosen the tilt adjusting screw and move to the
desired angle, then firmly tighten the tilt adjusting screw.
CAUTION: The fan should be switched off when making this adjustment.
Please note that the head will not latch into the low or mid position until the guard
and blade are fitted to the motor.
4. To adjust the height of the pedestal fan. Loosen the height adjustment nut carefully
raising or lowering the fan and firmly re-tighten the height adjustment nut.
CAUTION: The fan should be switched off when making this adjustment.
Advertisement
