TechVision DVR-LT04120 User Manual page 80

You can set for each channel. The function consists of three types. The priority is:
alarm>motion detection>schedule.
5.5.8.6.1 Scheduled Video Output (Sch
Please enable corresponding video output item a
the tour output channel. System maximally supports 16 channels. Now system can
implement tour output as you just set.
Highlighted
here
5.5.8.6.2 Alarm Activation Matrix
Please go to alarm setup interf
Menu->Setting->Alarm)). See Figure 5-42. You can follow the steps listed below:
 Select local alarm
 The record channel f
corresponding record channel.
 The video matrix function has be
corresponding video matrix channel.
Afte r selecting activation channel in the re
matrix function and then select vide output channel. Once the alarm occurs, system
continues scheduled matrix tour after alarm tour completes. If there is no scheduled
tour available, the matrix will stop at the last activation channel after alarm completes
When there are several alarm inputs at the same time, the situation maybe a little bit
complex. Here is an example.
System setup is shown as belo
 Alarm input 1 can activate chan
 Alarm input 2 can activate channel 2/3/4/5/6/7
eduled Tour)
Select ALL
or cancel
Figure 5-41
ace to set the alarm activate matrix function ((Main
unction has been enabled and you have selected
en enabled and you have selected
cord channel item, you can enable video
w:
nel1/2/3/4/5/6
nd input tour interval, and then set
Select
channe l(s) here
Input interval here
/8
.
80