TechVision DVR-LT04120 User Manual page 116

 Pan/Tilt/Zoom
Pan/Tilt/Zoom interface is shown as in Figure 7-43.
Please note you have properly set dome address and all connections are right.
 Decoder: Select the dome connected channel.
 Protocol: select the corresponding dome protocol.(such as Pelco)
 Address: Set corresponding dome address. Default value is 1. Please note your
setup here shall comply with your dome address; otherwise you can not control
the speed dome.
 Baud rate: Select the dome baud rate. Default setup is 9600.
 Data bit: Default setup is 8.
 Stop bit: Default setup is 1.
 Parity: Default setup is none.
 Tool
Here you can export or import configuration information. See Figure 7-44.
Figure 7-42
Figure 7-43
116