Datalogic Skorpio X3 User Manual page 29

BATTERIES AND MAINTENANCE
Cleaning the Dock Contacts
1. Remove the power cable before cleaning the contacts.
2. Use a soft dry cloth as suggested above. If the product is very dirty, moisten the cloth
in a non-aggressive cleaning solution or diluted isopropyl alcohol solution (20%
maximum).
3. Gently rub the cloth back and forth ONLY along the contacts, following the directions
indicated by the red arrows. Use care not to leave any cloth residue.
4. Use a dry cloth to remove any dirt near the contacts area and to clean the plastic
parts. If the plastic parts of the equipment are very dirty, slightly dampen the cloth
with only water.
5. Repeat steps 2, 3 and 4 using a clean dry cloth.
6. Allow the cleaning solution to fully evaporate before powering up the product.
2
21