Mercedes-Benz E-Class Sedan Operator's Manual page 313

! The jack is designed exclusively for jack-
ing up the vehicle at the jacking points.
Otherwise, your vehicle could be damaged.
Observe the following when raising the vehi-
cle:
To raise the vehicle, only use the vehicle-
R
specific jack that has been tested and
approved by Mercedes-Benz. If used incor-
rectly, the jack could tip over with the vehi-
cle raised.
The jack is designed only to raise and hold
R
the vehicle for a short time while a wheel
is being changed. It is not suited for per-
forming maintenance work under the vehi-
cle.
Avoid changing the wheel on uphill and
R
downhill slopes.
Before raising the vehicle, secure it from
R
rolling away by applying the parking brake
and inserting wheel chocks. Never disen-
gage the parking brake while the vehicle is
raised.
The jack must be placed on a firm, flat and
R
non-slip surface. On a loose surface, a
large, flat, load-bearing underlay must be
used. On a slippery surface, a non-slip
underlay must be used, e.g. rubber mats.
Do not use wooden blocks or similar
R
objects as a jack underlay. Otherwise, the
jack will not be able to achieve its load-
bearing capacity due to the restricted
height.
Make sure that the distance between the
R
underside of the tires and the ground does
not exceed 1.2 in (3 cm).
Never place your hands and feet under the
R
raised vehicle.
Do not lie under the vehicle.
R
Do not start the engine when the vehicle is
R
raised.
Do not open or close a door or the trunk lid/
R
tailgate when the vehicle is raised.
Make sure that no persons are present in
R
the vehicle when the vehicle is raised.
AMG vehicles with Performance Studio
equipment: the wheel bolts are covered by a
hub cap. Before you can unscrew the wheel
bolts, you must remove the hub cap.
To remove: turn the center cover of hub
X
cap : counter-clockwise and remove.
To install: before installing, ensure that
X
hub cap : is in the open position. To do
this, turn the center cover counter-clock-
wise.
Position hub cap : and turn the center
X
cover clockwise until hub cap : engages
physically and audibly.
Make sure that hub cap : is installed
X
securely.
Using lug wrench ;, loosen the bolts on
X
the wheel you wish to change by about one
full turn. Do not unscrew the bolts com-
pletely.
I n f o r ma t i o n P r o v i d e d b y :
Changing a wheel
311
Z