Checking The Oil Level - Mercedes-Benz E-Class Sedan Operator's Manual

WARNING
G
When the hood is open and the windshield
wipers are set in motion, you can be injured by
the wiper linkage. There is a risk of injury.
Always switch off the windshield wipers and
the ignition before opening the hood.
! Make sure that the windshield wipers are
not folded away from the windshield. You
could otherwise damage the windshield
wipers or the hood.
Make sure that the windshield wipers are
X
turned off.
Pull release lever : on the hood.
X
The hood is released.
Reach into the gap, pull hood catch han-
X
dle ; up and lift the hood.
If you lift the hood by approximately 15 in
(40 cm), the hood is opened and held open
automatically by the gas-filled strut.
Closing the hood
Lower the hood and let it fall from a height
X
of approximately 8 in (20 cm).
Check that the hood has engaged properly.
X
If the hood can be raised slightly, it is not
properly engaged. Open it again and close
it with a little more force.
Radiator
Vehicles with a diesel engine: do not cover
the radiator, for example with a winter front or
bug cover. The readings of the on-board-diag-
nostic system may otherwise be inaccurate.
Some of these readings are required by law
and must be accurate at all times.
Engine oil
General notes
G WARNING
Hybrid vehicles: be sure to read the "HYBRID"
supplement. Otherwise, you could fail to rec-
ognize dangers.
Depending on your driving style, the vehicle
consumes up to 0.9 US qt (0.8 liters) of oil per
600 miles (1,000 km). The oil consumption
may be higher than this when the vehicle is
new or if you frequently drive at high engine
speeds.
Depending on the engine, the oil dipstick may
be in a different location.
When checking the oil level:
park the vehicle on a level surface.
R
the engine should be switched off for
R
approximately five minutes if the engine is
at normal operating temperature.
if the engine is not at normal operating
R
temperature, e.g. if the engine was only
started briefly, wait about 30 minutes
before carrying out the measurement.
I n f o r ma t i o n P r o v i d e d b y :
Engine compartment
263
Z