Advertisement
Quick Links
Welcome
Your mouse uses new generation technology – a laser module that
replaces the traditional LED mouse and provides amazing tracking
ability. You can work with your mouse on most surfaces perfectly,
even glass topped surfaces. It also uses a digital radio technology for
convenient wireless connectivity combined with a rechargeable
receiver for you to keep your mouse charged and ready to use.
Safety Notice
1. This product complies with IEC 60825-1, class 1 laser
product.
2. Your product complies with FCC, CE and C-Tick rules.
3. This product has no serviceable parts. Use of controls or
adjustments of procedures other than specified in the user
guide may be hazardous.
Important Note
Please charge the batteries for 7 hours before
you use your mouse for the first time.
Please DO NOT direct the laser beam at anyone's eye.
Advertisement
Related Manuals for Belkin F8E729
Summary of Contents for Belkin F8E729
- Page 1 Welcome Your mouse uses new generation technology – a laser module that replaces the traditional LED mouse and provides amazing tracking ability. You can work with your mouse on most surfaces perfectly, even glass topped surfaces. It also uses a digital radio technology for convenient wireless connectivity combined with a rechargeable receiver for you to keep your mouse charged and ready to use.
-
Page 2: Mouse Layout
Mouse Layout: Mouse wheel Low power LED OFF/ ON Switch Lift sensor Channel reset button Battery cover Previous /Office hot key/ Next page Installing the Batteries Step 1 Pull up the battery cover of the mouse. Step 2 Insert the batteries as shown inside the battery compartment. Step 3 Replace the cover. - Page 3 Install the Receiver and the Charger The receiver (charger) is connected to your computer via a USB cable. It needs to plug into your computer by a USB port or a PS2 mouse port. Connec t to the USB or Mo use p ort of your c om p uter PS/2 Port For PS/2 port installation Please turn off your computer before plugging in the...
- Page 4 This Mouse is a plug-and-play device. Normally, it’s not necessary to setup the RF Channel for wireless communication. But if some interference happens, then you must setup the connection by resetting the RF Channel. Setup the RF Channel connection between the Mouse and the Receiver Push the channel reset button on the m ouse.
- Page 5 Recharging: RED LED FLASH Low power RED LED OFF Norm al / No batteries RED LED ON Recharging RED LED OFF Finished charging Please Note The mouse will not recharge properly if plugged into a non-powered USB hub.
-
Page 6: Using Your Mouse
Using your Mouse How to use the wheel Your mouse has a wheel that functions both as a wheel for Windows scrolling and also as a customized button. It can be used as a standard mouse button, click (press down) the wheel. For scrolling on screen, simply move the wheel. - Page 7 Quick Panel Launch Word Launch Excel Adjust Volume Launch PowerPoint Launch Outlook Launch My Computer Open My Document Launch IE (Tips: There are popup tips when you point on the screen icons.) Utility Settings Double click the mouse icon on the right bottom corner of the Windows screen to get into the settings window.
-
Page 9: Troubleshooting
Troubleshooting A. Mouse does not work upon installation Try one or more of the following: For optimal performance, adjust the angle of the receiver to find the best performance. You must use this mouse a flat surface. Make sure you have installed the batteries correctly. Press the “Channel Reset”... - Page 10 D. Mouse does not work upon installation. Try one or more of the following: Make sure you have installed the Driver correctly. Make sure the receiver cable is plugged in to the right PS2 port or USB port. Unplug the receiver and then plug in the receiver again. Make sure that it has been detected by the Operating Systems properly.