Installation - Smeg SHU500X Instruction Manual

INSTALLATION

• The hood can be installed either directly on the bottom surface of the
wall units (min. 650 mm above the hob).
• Cut a fitted opening in the bottom surface of the wall unit, as shown.
• Fix using the 8 screws 12a provided.
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney us-
ing either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is
left to the installer.
• To install a ø 120 mm air exhaust connection, insert the reducer flange
9 on the hood body outlet.
• Fix the pipe in position using sufficient pipe clamps (not supplied).
• Remove possible charcoal filters.
RECIRCULATION VERSION AIR OUTLET
• Connect the flange to the outlet on the shelf over the hood using a flexi-
ble or rigid pipe (ø120 or 150 mm).
• To install a ø 120 mm air exhaust connection, insert the reducer flange
9 on the hood body outlet.
• Fix the pipe in position using sufficient pipe clamps (not supplied).
• Ensure that the activated charcoal filters have been inserted.
• Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm..
EN
SCREWS FITTING
Connections
ELECTRICAL CONNECTION
259
13
12a
ø 150 ø 120
9
5 5