Filling In The Water Tank; Steam Ironing - Beko BKK 2174 User Manual

4 Operating the product

4.2 Filling in the water tank

1. Grab the handle (1) of the water tank
(8) and pull the water tank out of the
steam ironing station by pushing the
trigger underneath the handle.
2. Open the lid of the water filling
opening (11) and fill the water tank
(8) with tap water or distilled water
up to the MAX marking. The maxi-
mum capacity is 1.7 liters.
3. Close the lid of the water filling
opening and push the water tank (8)
completely into the steam ironing
station. Make sure that it clicks into
place properly and is secured to the
housing of the steam ironing sta-
tion.
During water intake,
C
the device may create
noise due to its pump
operation, this is a nor-
mal condition.
If your tap water is very
C
hard it is recommended
to mix the tap water
with distilled water on a
50:50 ratio, or use dis
tilled water only.
18 / 45 EN

4.3 Steam ironing

1. Place the appliance on an even, dry
and nonslip surface. The non-slip
feet (22) ensure the stability of the
appliance.
2. Fill the water tank as described
in the section "Filling in the water
tank".
3. Insert the power plug (7) into the
socket.
4. Push the On/Off switch (20) to
switch on the steam ironing station.
– Power indicator (14) lights in red
and ECO indicator (17) starts to
flash in green. When it is ready
for steam ironing the green light
will be on continuously.
5. Adjust the temperature control dial
(12) to the desired temperature.
– The temperature indicator
light (3) lights up red. The red
temperature indicator light (3)
remains on while the iron is
heating up. As soon as the iron
reaches the set temperature, the
temperature indicator light goes
off. The temperature indicator
light will go on and off during
usage to indicate that the set
temperature is being regulated.
Steam Iron Station / User Manual