Removing The Laundry At The End Of The Programme; End Of Programme/Anti-Crease; Removing The Laundry - Miele TKG 450 WP Operating Instructions Manual

4. Removing the laundry at the end of the programme

End of programme/Anti-crease

At the end of the programme: Anti-
crease/Finish (if anti-crease has been
selected) or Finish will light up. The
Start/Stop button will no longer be lit
up.
To save energy, 10 minutes after the
end of the programme the Start/Stop
button will begin to flash slowly and the
display will go out.
The dryer will switch off automatically
15 minutes after the end of the anti-
crease phase (with programmes without
an anti-crease phase it will switch off
15 minutes after the end of the
programme).

Removing the laundry


Never open the door before the
drying process has finished.
 Reach under the door grip and pull
the door open.
 Remove the laundry.
28
Check that all items have been
removed from the drum.
If items are left in the dryer, they
could be damaged by overdrying
when the dryer is next used.
If the dryer is switched on at the mains
and the door is opened, the drum
lighting will come on. It will go out a few
minutes later to save energy.
 If the dryer is still switched on, switch
it off with the  button.
A buzzer will sound.
 Remove the fluff from the 2 fluff filters
in the door opening (see "Cleaning
and care - Fluff filters").
 Shut the door with a gentle swing.
 Empty the condensed water
container.
Useful tip: The condensed water can
be used for the Steam smoothing
programme. See "Cleaning and care -
Preparing the condensed water
container for Steam smoothing".