Installation - Whirlpool JT469 Instructions For Use Manual

Table of Contents

Advertisement

PRIOR TO CONNECTING
Position the oven at a distance from other heating sources. For sufficient venti-
lation there must be a space of at least 30 cm above the oven.
The microwave oven shall not be placed in a cabinet. This oven is not intended
to be placed or used on a working surface lower than 850 mm above the floor.
Check that the voltage on the rating plate corresponds to the voltage in your home.
Do not remove the microwave inlet protection plates located on the side of the oven cavity wall. They prevent
grease & food particles from entering the microwave inlet channels.
Place the oven on a stable, even surface that is strong enough to hold the oven and the food utensils you put in
it. Use care when handling.
Ensure that the space underneath, above and around the oven is empty to allow for proper airflow.
Ensure that the appliance is not damaged. Check that the oven door closes firmly against the door support and
that the internal door seal is not damaged. Empty the oven and clean the interior with a soft, damp cloth.
Do not operate this appliance if it has a damaged mains cord or plug, if it is not working properly, or if it has
been damaged or dropped. Do not immerse the mains cord or plug in water. Keep the cord away from hot sur-
faces. Electrical shock, fire or other hazards may result.
Do not use extension cord:
If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the appli-
ance.
WARNING: Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electri-
cian or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
AFTER CONNECTING
The oven can be operated only if the oven door is firmly closed.
Poor television reception and radio interference may result if the oven is located close to a TV, radio or aerial.
The earthing of this appliance is compulsory. The manufacturer will accept no responsibility for injury to per-
sons, animals or damage to objects arising from the non-observance of this requirement.
The manufacturers are not liable for any problems caused by the user's failure to observe these instructions.

INSTALLATION

GB
3

Advertisement

Table of Contents
loading

Table of Contents