Car Seat With Adjustable Back; Car Seat With Fixed Back; Adjusting Harness Strap Height - Baby Trend Secure Snap Gear 32 CS61 Owner's Manual

Harness System Use and Adjustment
11.0
Removing Your Child from Harness System
1. Open Harness Clip by pressing button and sliding apart.
2. Unbuckle the Harness Buckle by pressing the red button.
3. Press the Harness Adjuster Button and pull outward on the
straps to loosen.
4. Slide the harness straps off the child's shoulders and arms.
5. Remove your child.

11.2 Adjusting Harness Strap Height

11.2.1 Car Seat with Adjustable Back

The Car Seat includes a sliding Adjustable Back that will adjust
the height of the harness straps as the back is adjusted.
1. The proper height of the harness straps is at or
just below your child's shoulders.
2. Rotate the knob behind the seat back to raise or
lower the moving seat back and harness straps.
- To adjust the seat back height, turn the moving
back adjuster knob behind the seat clockwise
to increase the seat back height and counter
clockwise to decrease the seat back height.
Each half turn will raise or lower the slots 12.5
mm (1/2").
51
Harness System Use and Adjustment
11.0
- Knob must remain in vertical position
after adjustment. (Fig 52-1) DO NOT
use the Car Seat with the Harness
adjusted above the child's shoulders as
the child will not be held securely in a
sharp turn, sudden stop, or crash.

11.2.2 Car Seat with Fixed Back

The fixed seat back model of the Car Seat features
three height adjustments for the harness straps.
The harness straps must be used in the slots that
position the straps even with or just below your child's
shoulders (Fig 52-2). The harness straps are adjusted
as follows:
1. Remove the Car Seat from the Base and rotate
the Carry Handle to the storage or non-rocking
position. Place your child in the Car Seat such
that your child's bottom is all the way to the rear
and bottom of the seat.
2. Determine which pair of harness slots will position the
harness straps even with or just below your child's
shoulders. (Fig 52-3) DO NOT use harness slots that will
position the harness straps above your child's shoulders
as the harness straps in this position will not restrain a
small child in a sharp turn, sudden stop or crash.
Knob handle must
be vertical
52-1
52-2
52-3
52