Final Safety Check; Additional Information; Care & Maintenance - Baby Trend Secure Snap Gear 32 CS61 Owner's Manual

Harness System Use and Adjustment
11.0
Car Seat without Base:
• Place car seat onto vehicle seat. Check that
car seat is level side to side. (Fig 59-1)
• Check the Seat Angle Indicator that
matches the weight of your child. (Fig 59-2)
• If the Seat Angle Indicator shows NO red,
the seat is installed at the proper seat
recline angle.
• If the Seat Angle Indicator shows ANY red,
the Car Seat is either too upright or too
reclined. If the Car Seat is too reclined adjust
the Car Seat as shown in (Fig 59-3) until the
Seat Angle Indicator shows NO red. If the
Car Seat is too upright, place a tightly rolled
towel, or car seat solid noodle, under the
foot end of the Car Seat until the Seat Angle
Indicator shows NO red. (Fig 59-4)
Re-tighten the vehicle seat belt. Check the
Seat Angle Indicator to see if the seat is now
level (no red showing).
59-1
(10 kg) and
(10 to 14.5 kg)
59-2
59-3
59-4
59
12.0 FINAL SAFETY CHECKS
1. If your child is already in the Car Seat, check that the harness is
properly fitted and snugly adjusted as instructed in the section 11.1
Securing Your Child with Harness System.
2. Check that UAS connectors are securely attached and UAS belt or
vehicle seat belt is tightly adjusted around base.
3. Remove any toys or other objects attached to carry handle.
4. Adjust carry handle into desired adjustment position. The storage
position is the preferred position for use in a vehicle.

13.0 ADDITIONAL INFORMATION

13.1 Care & Maintenance
Vehicle seat: Use a child restraint mat, towel or other cloth to protect
vehicle seat upholstery. Continuous use of a child restraint may cause
damage to an unprotected vehicle seat.
Car Seat – Plastic and Metal components: Clean with mild soap and
cold water. DO NOT use bleach or harsh detergents.
Buckle Adjuster and UAS Connectors: Wipe clean with damp cloth
ONLY. If buckle/UAS connectors will not securely lock, DO NOT use this
child restraint. DO NOT use lubricants of any kind on any of the components
of the Car Seat and Base, including the buckle and UAS system.
Harness Straps: Spot clean with damp cloth or replace. DO NOT immerse
straps in water. The straps may weaken and not perform as designed.

Final Safety Check

12.0
60