Table of Contents
Advertisement
AcquisitionControl
Make a setting of image stream and control image stream output.
Camera starts image stream output by receiving AcquisitionStrat command. And there are some registers
that require camera to stop image stream output to change values.
Acquisition frame rate is variable. Maximum acquisition frame rate depends on camera operation mode
(scalable, binning, decimation, link speed, etc.)
● Registers
Register
AcquisitionMode
AcquisitionStart
AcquisitionStop
AcquisitionAbort
AcquisitionFrameBurstCount
AcquisitionFrameRate
● Setting
- Start image stream output
The camera starts image stream output by executing "AcquisitionStart" register command.
- Stop image stream output
The camera stops image stream output by executing "AcquisitionStop" register command.
The camera aborts image stream output by executing "AcquisitionAbort" register command.
- Sets number of Exposures for FrameBurstStart trigger
Set the following value to "AcquisitionFrameBurstCount" register. Setting value is Integer type.
Copyright © 2014 TOSHIBA TELI CORPORATION, All rights reserved.
Visibility
Access
Beginner
R
Returns acquisition mode.
Beginner
W
Executes the image stream output start.
Beginner
W
Executes the image stream output stop.
Beginner
W
Executes the image stream output abort.
Beginner
R/W
Sets number of Exposures to acquire for each FrameBurstStart trigger.
Beginner
R/W
Sets frame rate of image stream.
FrameBurstCount
Minimum (*)
Maximum
Description
Value
1 [time]
255 [times]
* initial factory setting
44 / 80
D4235067D
http://www.toshiba-teli.co.jp/index.htm
Advertisement
Table of Contents
