Table of Contents
Advertisement
Connection
● In the case of supply DC+12V to the camera.
BG Series
Camera
Camera mounting kit
CPT8600
● In the case of supply PoE power to the camera.
BG Series
Camera
Camera mounting kit
CPT8600
Notes on Connection:
- Please confirm the power supply of the camera off when plugging in or pulling out the I/O Connector. It causes the
breakdown.
- If your camera is used in a system where its connectors are subjected to strong repetitive shocks, its connectors are
possible to break down. If you use your camera in such a situation, use an LAN cable with a lock screw, and secure
the camera cable as close as possible to the camera body for avoid physical shock to the camera connector.
- About Camera cable: In the case that electric-wire is long or thin, input voltage may not satisfy specifications of the
power supply voltage of the camera by voltage drop. Please confirm it before use.
-
Lost packets may occur by an electrical characteristic of the transmission line of using Ethernet devices (LAN cable,
Network Interface Card, Switching HUB).
Copyright © 2014 TOSHIBA TELI CORPORATION, All rights reserved.
LAN Cable
← Control Packet
1. DC+12V IN
2. LINE0 IN
3. LINE1 OUT
4. LINE2 OUT
5. I/O GND
6. GND
LAN Cable
← Control Packet
← PoE Power
PoE Switching HUB etc.
Fig.4-1 Connection
16 / 80
Stream Packet →
Network Interface
Stream Packet →
Network Interface
http://www.toshiba-teli.co.jp/index.htm
Host (PC etc.)
Card
Host (PC etc.)
Card
D4235067D
Advertisement
Table of Contents
