Table of Contents
Advertisement
Removing the flywheel
1.
Prior to performing the following procedure, remove
the head relay P.W.B, the load arm, the sub chassis,
the cassette holder, the holder arm and the reel disc
P.W.B.
2.
Remove the belt on the bottom of the cassette
mechanism ass'y.
3.
Remove the slit washer attaching the flywheel on the
upper side of the cassette mechanism ass'y and pull
out the flywheel downward. Then remove another
flywheel in the same way.
ATTENTION:
When reassembling, make sure to use
a new slit washer.
Removing the reel disc ass'y( )
*
Prior to performing the following procedure, remove
the head relay P.W.B, the load arm, the sub chassis,
the cassette holder and the holder arm.
1.
Disengage the part n inside of the reel driver which
engages with the shaft, using a pincette or
something like that. Then remove the reel driver from
the shaft.
2.
Remove the reel driver spring and the reel table.
(See Fig.10 and 12)
(See Fig.12 to 14)
KS-FX850R/KS-FX835R/KS-FX820R
Reel disc P.W.B.
Soldering j
Tab k
G
Motor
G
Slit washer
Tab o
Plate
The part n
Slit washer
Reel driver
Shaft
The part n
Fig.13
Reel driver spring
Reel table
Cassette mechanism ass'y
Tab k
Flyhwheel
Belt
Fig.10
Reel driver
Reel disc
The part n
ass'y( )
Tabs o
Push aside
the gear
Reel disc ass'y( )
Fig.12
Reel driver
Fig.14
2-7
Advertisement
Table of Contents
