Maintenance - Black & Decker CS2000 Instruction Manual

WARNING: Check the work surface that the chop saw rests on when replacing with a new abrasive wheel. It
is possible that the wheel may contact ANY ITEMS OR STRUCTURE THAT EXTENDS ABOVE work surface (under
the base) when the arm is fully lowered.
OPERATION TIPS FOR MORE ACCURATE CUTS
• Allow the wheel to do the cutting. Excessive force will cause the wheel to glaze reducing cutting efficiency
and/or to deflect causing inaccurate cuts.
• Properly adjust fence angle.
• Make sure material is laying flat across base.
• Properly clamp material to avoid movement and vibration.

MAINTENANCE

MOTOR BRUSH INSPECTION AND REPLACEMENT (FIG. 9)
WARNING: Turn off and unplug the tool. Be sure the trigger switch is in the OFF position.
Brushes should be regularly inspected for wear. To inspect brushes, remove brush cap (W). Brushes (V) should
slide freely in brush box. If brushes are worn down to .3" (8mm) as shown in Figure 9 they should be replaced.
To reinstall, push new brush back into brush box. If replacing existing brush, maintain same orientation as when
removed. Replace the brush cap (do not overtighten).
CLEANING
Blowing dust and grit out of the main housing by means of an air hose is recommended and may be done as
often as dirt is seen collecting in and around the air vents. Always wear proper eye and respiratory protection.
REPAIRS
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by
authorized service centers or other qualified service organizations, always using identical replacement parts.
LUBRICATION
Closed-type, grease-sealed ball bearings are used throughout. These bearings have sufficient lubrication
packed in them at the factory to last the life of the chop saw.
ACCESSORIES
CAUTION: The use of any other accessory not recommended for use with this tool could be hazardous.
Use only high-strength Type 1 organic bonded wheels rated 4300 rpm or higher.
Recommended accessories for use with your tool are available at extra cost from your local dealer or authorized
service center.
SERVICE
Black & Decker offers a full network of company-owned and authorized service locations. All Black & Decker
Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool
service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black &
Decker location nearest you.
25
ENGLISH