Mld Snooping-Proxy Vlan Filtering Profile - ZyXEL Communications GS1920 series User Manual

23.5.5 MLD Snooping-proxy VLAN Filtering Profile

Use this screen to create an MLD filtering profile and set the range of the multicast address(es).
Click the Filtering Profile link in the Advanced Application > Multicast > IPv6 Multicast >
MLD Snooping-proxy > Filtering screen to display the screen as shown.
Figure 134 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering >
Filtering Profile
The following table describes the fields in the above screen.
Table 80 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
Profile
LABEL
Profile Name
Start Address
End Address
Add
Clear
Profile Name
Start Address
End Address
Chapter 23 Multicast
DESCRIPTION
Enter a descriptive name for the profile for identification purposes.
To configure additional rule(s) for a profile that you have already added, enter
the profile name and specify a different IP multicast address range.
Type the starting multicast IPv6 address for a range of multicast IPv6 addresses
that you want to belong to the MLD filtering profile.
Type the ending multicast IPv6 address for a range of IPv6 addresses that you
want to belong to the MLD filtering profile.
If you want to add a single multicast IPv6 address, enter it in both the Start
Address and End Address fields.
Click this to create a new entry.
This saves your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Clear to reset the fields to the factory defaults.
This field displays the descriptive name of the profile.
This field displays the start of the multicast IPv6 address range.
This field displays the end of the multicast IPv6 address range.
GS1920 Series User's Guide
182