Table of Contents
Advertisement
Using the EM 9046
72 |
Digital 9000
If you have extended the EM 9046's hardware configuration, this is dis-
played in the
"hw
setup" menu item with the status "added":
p
Slot
Module Type
RX1
EM 9046 DRX
RX2
EM 9046 DRX
RX3
EM 9046 DRX
RX4
EM 9046 DRX
RX5
EM 9046 DRX
RX6
EM 9046 DRX
RX7
EM 9046 DRX
RX8
EM 9046 DRX
MAN
EM 9046 DAN
OUT1
EM 9046 AAO
OUT2
EM 9046 DAO
ASP
EM 9046 ASP
In both cases, the
"Press SET to
In the
"hw
setup" menu item, you confirm modifications as follows:
Press the jog dial.
The
"Press SET to
confirm" button is framed in blue and
confirm hw
setup" appears in the menu selection.
button F.
Press the
"Firmware" – Displaying the hardware versions/firmware
versions and updating the firmware
EM9046_3_0_2_11476
Antenna booster
Update to firmware:
12-05-07-09
RF IN A:
AB9000_4
Firmware:
12-05-07-09
RF IN B:
AB9000_4
Firmware:
12-05-07-09
If you update the EM 9046 receiver's firmware using the WSM software,
the current firmware versions of the 9000 series boosters and transmit-
ters are also stored on the receiver.
Via the "Firmware" menu item, you can display the firmware versions of
the receiver, the boosters and the transmitters and update the firmware
of the boosters and the transmitters.
The currently installed firmware version of the EM 9046 is displayed in the
menu selection (see above).
State
ok
ok
ok
ok
ok
ok
ok
ok
ok
ok
added
ok
confirm" button is highlighted in blue.
Transmitter
SCAN ONLY MODE
Start update mode
Transmitter:
Firmware:
New firmware:
"Press save to
firmware
Advertisement
Table of Contents
