Advertisement
1.
Attach the two plastic feet to the bottom, then fix with the
provided screws with the help of a screwdriver. Each foot
should be secured with 4 screws.
2. Be sure to place the heater on a flat, stable surface.
The device must be installed so that airflow is not obstructed.
•
The wall mounting should be performed by a qualified
•
person to avoid hazards.
The minimum distances between the device and ceilings,
•
ground and side walls, as shown to right, must be maintained.
1
2
3
4
5
6
7
8
9
3
1.
Decorative Glass
2. LCD Screen (blank when OFF)
3. Operation Buttons
4. Feet
5. Rear Cover
6. Power ON/OFF Switch
7. Power Cable
8. Sensor
9. Remote Controller
Advertisement
