Keep the appliance and cable away from other sources of heat, sharp objects or anything else that may cause damage. • If the cord is damaged, it must be replaced by Kogan.com in order to avoid a hazard. • Ensure the appliance is switched off before connecting to the mains power supply.
Page 4
• Children should be supervised to ensure that they do not play with the heater. • Do not leave the heater unattended while it is in use. • The most common cause of overheating is deposits of dust or fluff in the appliance. Ensure these deposits are removed regularly by disconnecting the appliance from the power supply, then vacuum cleaning the air vents and grilles.
Page 5
OVERVIEW 1. Decorative Glass 4. Feet 7. Power Cable 2. LCD Screen 5. Rear Cover 8. Sensor 3. Control Panel 6. Power Switch 9. Remote Control...
Page 6
ASSEMBLY Free-Standing • Attach the two plastic feet to the bottom and use the provided screws to secure them. Each foot should be secured with 4 screws. • Install the heater on a flat, stable surface. Wall Mounting min. 60cm min.
Page 7
Installation location and important notes: • Ensure airflow is not obstructed. • The wall mounting should be performed by a qualified person to avoid hazards. • Observe the minimum distances between the device and ceilings, ground and walls. • Ensure there are no cables or other pipelines behind the wall to avoid damage prior to drilling.
Page 8
Attach the wall bracket lock piece onto the bracket with screws and slide the lock piece into the locking slot on the back of the heater. Tighten the screws: Wall Bracket lock piece • During installation, the heater must be kept a sufficiently safe distance from combustible materials/gases and away from water.
OPERATION Connect the heater to a power socket, then turn on with the ON/OFF switch on the side panel. Press the buttons on the operation panel or remote control to set the heating. Setting Mode OFF (Stop) 1000W 2000W Press the “ ”...
Page 10
Setting Temperature The temperature can only be set under Comfortable or Economical mode. Under ECO and Frost-free modes, the set temperature is locked to 18°C and 5°C respectively. Press the temperature button, then use the UP/DOWN buttons to set the temperature between 15°C to 50°C.
Inspect for blockages of the air inlets or outlets, attempting to restart the heater after. If the heater fails to operate or the safety device switches the heater off again, contact the Kogan.com customer support team for further information. Storage Always disconnect the heater, allow it to cool and then clean it before storing it.
Page 12
Need more information? We hope that this user guide has given you the assistance needed for a simple set-up. For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.kogan.com...