Subaru 2001 IMPREZA Service Manual page 33

BRAKE
8) Install lock and guide pin boot on support.
(1) Pin boot
(2) Lock pin or guide pin
(3) Apply grease.
2. 15 INCH TYPE
1) Clean caliper body interior using brake fluid.
2) Apply a coat of brake fluid to piston seal and fit
piston seal in groove on caliper body.
3) Apply a coat of brake fluid to the entire inner sur-
face of cylinder and outer surface of piston.
4) Insert piston into cylinder.
CAUTION:
Do not force piston into cylinder.
5) Apply a coat of specified grease to boot and fit in
groove on ends of cylinder and piston.
Grease:
NIGLUBE RX-2 (Part No. 003606000)
To facilitate installation, fit boot starting with piston
end.
FRONT DISC BRAKE ASSEMBLY
B4M1176B
B4M0771
BR-32
(1) Piston boot
(2) Boot ring
(3) Piston seal
(4) Caliper body
6) Position boot in grooves on cylinder and piston.
7) Install boot ring. Be careful not scratch boot.
8) Apply a coat of specified grease to lock pin and
guide pin, outer surface, cylinder inner surface, and
boot grooves.
Grease:
NIGLUBE RX-2 (Part No. 003606000)
(1) Pin boot
(2) Lock pin or guide pin
(3) Apply grease.
9) Install lock pin boot and guide pin boot on sup-
port.
S4M0448A
B4M1176B