CDX-GT21W/GT210/GT260/GT260S
Ver. 1.1
• E model
This label is located on the bottom of the chassis.
• Chinese model
NOTE FOR REPLACEMENT OF THE SERVO BOARD
When repairing, the complete SERVO board (A-1177-201-A) should
be replaced since any parts in the SERVO board cannot be repaired.
NOTE FOR REPLACEMENT OF THE AUX JACK (J901)
To replace the AUX jack requires alignment.
1. Insert the AUX jack into the KEY board.
2. Place the KEY board on the front panel.
3. Solder the three terminals of the jack.
front panel
4
1.
2.
2-3. Main Board ...................................................................... 13
2-4. Servo Board ..................................................................... 13
3.
4.
KEY board
5.
5-1. Main Section .................................................................... 31
6.
AUX jack
TABLE OF CONTENTS
........................................ 16
.................................. 34