Inserting/Removing A Microsd Card - Panasonic HX-A1M Operating Instructions Manual

Inserting/removing a microSD card

When using a microSD card not from Panasonic, or one previously used on other equipment, for
the first time on this unit, format the microSD card.
all of the recorded data is deleted. Once the data is deleted, it cannot be restored.
Caution:
Check that the access lamp has gone off.

1
Rotate the terminal cover in the direction of the arrow to remove it.
2
Insert (remove) the microSD card into (from) the card slot.
≥ Insert the microSD card with its terminal side facing down. Push it straight in until it clicks into
place as shown in the figure.
≥ Press the centre of the microSD card and then pull it straight out.
3
Rotate the terminal cover in the opposite direction of Step 1 to attach it.
≥ Tighten it firmly to ensure that it is not loose.
≥ Do not touch the terminals on the back of the microSD card.
≥ For handling of microSD card, refer to page 51.
∫ About the access lamp
≥ When this unit is accessing the microSD card (the access lamp is lit/flashing), do not perform the
following:
j Remove the microSD card
j Turn this unit off
j Insert and remove the USB cable
j Expose this unit to vibrations or shock
Performing the above while the lamp is on may result in damage to data/microSD card or this unit.

- 14 -
(l 20) When the microSD card is formatted,
A Access lamp
≥ When this unit is accessing
the microSD card (e.g.,
detecting the card or
recording, playing back or
deleting files on it), the
access lamp will light/flash
red.
