About the Upgrade of the HX-A100 Firmware
The following functions were added or changed by Ver. 1.10 of the firmware.
Please read this in conjunction with the operating instructions for this unit.
From the Image App screen, tap
Update the version if it is earlier than Ver1.10.
To update the firmware of this unit, copy an update file to the microSD card, insert it into this unit,
and press the power button to turn on this unit while pressing and holding the Wi-Fi/WPS button
and the photoshot button.
If you are using the firmware version 1.10, use the latest version of the Image App.
∫ OS versions that support the Image App
≥ The supported OS versions are current as of April 2014 and subject to change.
≥ The service may not be able to be used properly depending on the type of smartphone being
For the latest information on version updates or for information on the Image App, see the
following support site.
(This Site is English only.)
The setup procedure using the setup wizard has been changed.
After making the settings according to the setup wizard screens, you can use the main functions of this unit.
Proceed to complete the setup by following the on-screen instructions.
≥ The setup wizard is displayed at the time of purchase and after a long period of non-use during
which the battery ran down.
Synchronise the time of this unit with that of smartphone.
≥ Once the clock is set, recording, live broadcasting, and other functions of this unit can be used correctly.
≥ It may take approximately 60 seconds to synchronise the time of the smartphone with that of this
≥ If the SSID and the password are set to their defaults, a message that recommends you to
change them will be displayed.
# [Camera setup] # [Device info. display] to check the
Android 2.3.3 or later
iOS 5.0 or later