Optional Accessories - Panasonic HX-A1M Operating Instructions Manual

Others

Optional accessories

Some optional accessories may not be available in some countries.
About the Video Camera Mount (For Handlebar)
You can attach the Video Camera Mount (For Handlebar)/RP-CMC10 as follows.
≥ To use the Video Camera Mount (For Handlebar)/RP-CMC10, the Tripod Mount (supplied) is
required.
≥ Please also refer to the operating instructions of the Video Camera Mount (For Handlebar).
≥ Refer to page 26 for information on the Tripod Mount.
∫ When attaching the Video Camera Mount (For Handlebar) and Tripod
Mount
1 Remove the Quick Shoe of the Video Camera Mount (For Handlebar) from the
camera platform.
2 Align the camera screw of the Quick shoe
with the tripod mounting hole of the Tripod
Mount, and insert the camera screw.
3 Turn the hinge at the back side of the Quick
Shoe to tighten the camera screw (clockwise).
≥ Hold the Tripod Mount with your hand so that it will not rotate with the camera screw.
≥ After tightening the camera screw, fix the hinge.
4 Attach the Quick Shoe to the camera platform.
≥ Align on the Quick Shoe with
until it clicks into place.
5 Attach this unit to the Tripod Mount.
∫ When removing the Video Camera Mount (For Handlebar) and Tripod
Mount
To remove the Video Camera Mount (For Handlebar) and Tripod Mount, perform the steps for
mounting them in reverse order.
on the camera platform, and push the Quick Shoe diagonally
(l 26)
- 54 -

A Tripod Mount (supplied)
B Camera screw
C Quick shoe

