Schumacher Electric SP1 Owner's Manual page 10

CHARGING
abort mode.
CHARGED
and the charger is in maintain mode.
CHARGED
of charge or higher.
12. OPERATING INSTRUCTIONS
Charging
1. Make sure to place the charger on a dry, non-flammable
surface, like metal or concrete.
2. Ensure that all of the charger components are in place and in
good working condition, for example, the plastic boots on the
battery clips.
3. Connect the battery, following the precautions listed in sections
6 and 7.
4. Connect the AC power, following the precautions listed in
section 8.
5. To disconnect, reverse the procedure.
NOTE: This charger is equipped with an auto-start feature. Current
will not be supplied to the battery clips until a battery is properly
connected. The clips will not spark if touched together.
Using The Quick-Connect Cable Connectors
Connect any of the three output cable leads to the charger. Make
sure to place the charger on a dry, non-flammable surface, like metal
or concrete.
NOTE: Never connect the clamp and ring terminal connectors
together for use in other applications, such as external battery or
other power source charging, or to extend the output cable length, as
reverse polarity and/or overcharge conditions will occur.
(yellow) LED flashing: Indicates the charger is in
(green) LED lit: Indicates the battery is fully charged
(green) LED blinking: Indicates the battery is at 80%
This battery charger must be properly assembled
in accordance with the assembly instructions before
it is used.
• 10 •