What You Need For Updating; Updating Procedures - Pioneer DDJ-SP1 Firmware Update Manual

Read Before Use (Important)
・ Be sure to follow the procedure in this guide to update
the firmware.
・ DO NOT disconnect the USB cable until updating is
completed.
・ If you should have any questions, please contact the
Pioneer Customer Support Center of your country.
Reference information
This updater has been verified to operate on the
operating systems below;
・ Windows： Windows® 8/Windows® 7
・ Mac OS X： 10.8/10.7/10.6
Approximately 2 minute is required for updating.

What you need for Updating

-Update file for DDJ-SP1
When the downloaded zip file is unzipped, the update file
appears. Place the update file on the desktop.
e.g.) DDJ-SP1_V101.jar
-A computer where Java has been installed
If Java has not been installed, please download the Java
Runtime Environment (JRE) at:
on your computer.

Updating Procedures

Note: Close all applications on your computer before running this
updating procedure.
1) Connect the above prepared computer to DDJ-SP1 via the
USB cable included with the product while pressing both the
effect parameter 1 and [TAP] buttons on the right side.
http://java.com and install it
2) Make sure that the LEDs of the [SYNC] button and the
[AUTO LOOP] knob on the both sides of the units flash
before releasing your finger from these buttons.
3) When the update file for DDJ-SP1 (DDJ-SP1_Vxxx.jar) is
activated, the following dialogue is displayed. Click the
[Start] button.
4) The update of the firmware starts.
5) When the firmware update process is complete, click the
[OK] button.
Make sure that the LEDs of the [SYNC] button and the [AUTO
LOOP] knob on the both sides of the units light before
disconnecting the USB cable from DDJ-SP1.
Note: Please note that if you fail to update, disconnect the
USB cable from DDJ-SP1 and start from Step 1) of the above
Updating Procedures.
1