Error Messages - Senor Tech ROBOT POS User Manual

5.7 Error Messages

Error Message
C: drive error
C: drive failure
Keyboard error
CMOS battery state low
CMOS system options not set
CMOS display type mismatch
Possible Cause
Power off and reseat the hard disk drive. Run CMOS
setup utility and ensure the correct hard disk type is
entered (Auto Detect). If possible try another known
working hard drive in the Upper Part If the new drive still
does not work the problem will be internal to the Upper
Part, either the internal HDD data or power cable not
connected or faulty, the Hard Disk "bay" is faulty or the
motherboard is faulty. If the replacement drive works,
replace the original drive and run DOS scandisk on the
drive, if the problem is not fixed, the drive is faulty and
will need to be replaced.
Power off and reseat the hard disk drive. Run CMOS
setup utility and ensure the correct hard disk type is
entered (Auto Detect). If possible try another known
working hard drive in the Upper Part If the new drive still
doesn't work the problem will be internal to the Upper
Part, either the internal HDD data or power cable not
connected or faulty, the Hard Disk "bay" is faulty or the
motherboard is faulty. If the replacement drive works,
replace the original drive and run DOS scandisk on the
drive, if the problem is not fixed, the drive is faulty and
will need to be replaced.
Ensure the keyboard cable from the keyboard I/R
receiver is connected securely to I/O board J23
Make sure the battery is working properly. Run the
CMOS Setup utility and enter the correct parameters.
Make sure the battery is working properly. Run the
CMOS Setup utility and enter the correct parameters
Make sure the battery is working properly. Run the
CMOS Setup utility and enter the correct parameters.
26