Error Messages - Senor Tech iSPOS User Manual

5.6 Error Messages

Error Message
C: drive error
C: drive failure
Keyboard error
CMOS battery state low
CMOS system options not set
CMOS display type mismatch
Possible Cause
Power off and reseat the hard disk drive. Run
CMOS setup utility and ensure the correct hard
disk type is entered (Auto Detect). If possible try
another known working hard drive in the iSPOS
If the new drive still does not work the problem
will be internal to the iSPOS, either the Hard
Disk "bay" is faulty or the motherboard is faulty.
If the replacement drive works, replace the
original drive and run DOS scandisk on the
drive, if the problem is not fixed, the drive is
faulty and will need to be replaced.
Power off and reseat the hard disk drive. Run
CMOS setup utility and ensure the correct hard
disk type is entered (Auto Detect). If possible try
another known working hard drive in the iSPOS
If the new drive still doesn't work the problem
will be internal to the iSPOS, either the Hard
Disk "bay" is faulty or the motherboard is faulty.
If the replacement drive works, replace the
original drive and run DOS scandisk on the
drive, if the problem is not fixed, the drive is
faulty and will need to be replaced.
Ensure the keyboard loopback plug and loop of
card reader connected properly
Make sure the battery is working properly. Run
the CMOS Setup utility and enter the correct
parameters.
Make sure the battery is working properly. Run
the CMOS Setup utility and enter the correct
parameters
Make sure the battery is working properly. Run
the CMOS Setup utility and enter the correct
parameters.
SENOR TECH CO., LTD.
iSPOS User's manual
28