Connecting To A Dual Aes Source - DCS Debussy DAC User Manual

dCS Debussy DAC User Manual

Connecting to a Dual AES Source

! For Dual AES mode to work correctly, the source must actually generate Dual AES data,
not just single AES on 2 connectors (which gives a mono output)!
Analogue outputs
to amplifier
Paganini Transport
Paganini Upsampler
• Connect the AES1 (or AES A) output on your source equipment to the
rear panel and the AES2 (or AES B) output to the
cables are not swapped.
• Press the
Input button repeatedly until the
source is active, the DAC will lock to the source and the appropriate sample rate indicator will
illuminate.
Proceed to Step 3.
Debussy DAC Manual v2_2x.docx
Figure 3 – Connecting the Dual AES interface.
AES 1
Page 10
AES1
AES2 input, using two XLR cables. Ensure the
and AES 2 input indicators illuminate. If the
Software Issue 2.2x
August 2013
input on the DAC's
English version